TG GripSerts for Workholding

With only 3.5mm of clamp surface needed to securely hold the workpiece, TG-type GripSerts workholding inserts are ideal for 5-axis machining operations. Because of the geometry of the grippers, the TG GripSerts workholding inserts create a pull down effect that prevents any lifting of the workpiece while clamping. These durable inserts combine a tough-coated cemented carbide with specialized teeth and triangular shapes that penetrate different types of workpieces material including steel, hardened steel/titanium (up to 50-54 HRC) and aluminum.

TG GripSerts workholding inserts offer many advantages over traditional clamping systems including exceptional clamping stability, no need for pre-machining or dovetailing workpieces, vibration dampening and allowing for very secure holding at lower clamping forces to avoid deforming the workpiece. This results in a higher cutting rate and less waste of materials than traditional clamping systems.

Browse these categories under "TG GripSerts for Workholding"

TG GripSerts - For Steel
These grippers are made to grip steel materials.
TG GripSerts - For Hardened Steel/Titanium
These grippers are made to grip hardened steel/titanium materials.
TG GripSerts - For Aluminum
These grippers are made to grip aluminum materials.
Protective Covers - For TG GripSerts
Protects jaws from dirt and debris when TG GripSerts workholding grippers are not installed.
Retrofit Jaw Set - Kurt 6 Inch
This jaw set allows you to use TG GripSerts workholding grippers on Kurt six-inch vises.
Retrofit Jaw Set - Kurt 6 Inch - with Parallels
This jaw set allows you to use TG GripSerts workholding grippers and Snap-in parallels on Kurt 6” vises.
Screws - For TG GripSerts
These screws are used to mount the TG GripSerts workholding grippers onto the TG GripSerts jaws.
Cutting Tool - For TG GripSerts
This milling cutting tool is used to prepare jaws to receive TG GripSerts workholding grippers.
Screwdriver - For TG GripSerts
Use this screwdriver to install or remove all TG GripSerts workholding grippers from the jaw sets.
Wrench - For TG GripSerts
Use this wrench to install or remove all TG GripSerts workholding grippers from the jaw sets.