With only 3.5mm of clamp surface needed to securely hold the workpiece, TG-type GripSerts workholding inserts are ideal for 5-axis machining operations. Because of the geometry of the grippers, the TG GripSerts workholding inserts create a pull down effect that prevents any lifting of the workpiece while clamping. These durable inserts combine a tough-coated cemented carbide with specialized teeth and triangular shapes that penetrate different types of workpieces material including steel, hardened steel/titanium (up to 50-54 HRC) and aluminum.
TG GripSerts workholding inserts offer many advantages over traditional clamping systems including exceptional clamping stability, no need for pre-machining or dovetailing workpieces, vibration dampening and allowing for very secure holding at lower clamping forces to avoid deforming the workpiece. This results in a higher cutting rate and less waste of materials than traditional clamping systems.
Browse these categories under "TG GripSerts"
These grippers are made to grip steel materials.
These grippers are made to grip hardened steel/titanium materials.
These grippers are made to grip aluminum materials.
Protects jaws from dirt and debris when TG GripSerts workholding grippers are not installed.
This jaw set allows you to use TG GripSerts workholding grippers on Kurt six-inch vises.
This jaw set allows you to use TG GripSerts workholding grippers and Snap-in parallels on Kurt 6” vises.
These screws are used to mount the TG GripSerts workholding grippers onto the TG GripSerts jaws.
This milling cutting tool is used to prepare jaws to receive TG GripSerts workholding grippers.
Use this screwdriver to install or remove all TG GripSerts workholding grippers from the jaw sets.
Use this wrench to install or remove all TG GripSerts workholding grippers from the jaw sets.