Sliding Mounts

Allow for both horizontal and vertical adjustments of clamps, supports, rests, etc.

Browse these categories under "Sliding Mounts"

Sliding Mount Unit
Allow for both horizontal and vertical adjustments of clamps, supports, rests, etc. The center block slides on the bottom block and the top block slides on the center block.
Slide Bases
Used with the Sliding Mount Units. They act as the base mount and provide a back stop so the clamping device does not slide backward on the mount.
Adjustable Swivel Stops
A vertical slot allows for the horizontal adjustment to slide up or down for various work piece height. The end of the horizontal adjustment swivels 20 degrees from center.
Side Stops
Used with the OK-Vise clamps. Can be used with the Sliding Mount Units and Replaceable Slide Bases.
Riser Pads
Used with Sliding Units to adjust height of clamps and stops.
Locating Adapters
Used with Sliding Units to adapt the hole to a threaded hole for attaching clamps and stops.
Round Adapters
Used with Sliding Units to adapt the hole to a threaded hole for attaching clamps and stops.